- 122 -
3 Three-line mode 2
This parameter defines four different modes of controlling the operation of the
driver via the external terminals.
0: Two-line running mode 1: This mode is the most commonly used two-line
mode. The forward/reverse rotation of the motor is decided by the commands
of FWD and REV terminals.
Fig.6-5 Two-line Running
1: Two-line running mode 2: When this mode is adopted, REV is enabled
terminal. The direction is determined by the status of FWD.
Fig.6-6Three-line running
2: Three-line running mode 1: In this mode, Dln is enabled terminal, and the
direction is controlled by FWD and REV respectively. However, the pulse is
enabled through disconnecting the signal of Dln terminal when the driver
stops.
Fig.6-7-1Three-line running
Where,
SB1: Stop button
SB2: Forward rotation button
K2 Running command
0 Stop
1 Reverse Rotation
IS300
FWD
REV
COM
K2
K1
K1
0
0
0 Forward Rotation
1 Stop
1
1
K2 Running Command
0 Stop
1 Stop
IS300
FWD
REV
COM
K2
K1
K1
0
0
0 Forward Rotation
1 Reverse Rotation
1
1
IS300
FWD
DIn
REV
COM
SB2
SB1
SB3
To Next Page
Loading...
