Inovance MD021 - Page 50

MD021 Plastic Wire Drawing Machine User Manual
set to 100, indicating that the deviation of PID feedback and PID
setting is 100%, the regulating amplitude required by the PID
regulator on the output frequency command is maximum frequency
(ignoring the integration and differential effects).
Integration time I: It decides the time of integral regulating on PID
feedback and PID setting. When the deviation of PID feedback and
PID setting is 100%, the integral regulator performs continuous
regulation during the time. Then the regulating amplitude reaches the
maximum frequency set in F0-02. The shorter the integral time is, the
greater the regulating intensity is.
Function
Code
Name
Range
Default
F2-05
PID upper limit
0% to 100%
2%
This parameter specifies the frequency upper limit of PID regulation.
This parameter is set based on a percentage of the maximum
frequency.
Function
Code
Name
Range
Default
F2-06
Lower limit for
wire-break detection
0% to 50%
5%
F2-07
Judging delay time of
wire-break detection
0s to 50s
3s