MD021 Plastic Wire Drawing Machine User Manual
0: No operation
1: Restore default
setting
2: Clear fault records
3: Parameter copy
reading
4: Parameter copy
writing
0: No function
1: Restore default setting (except for the following parameters)
Group F0 motor parameters: F0-06 to F0-09
Fault type parameters: F2-11 to F2-15
2: Clear fault records
Clear the fault records (F2-11 to F2-15) of the inverter.
3: Parameter copy reading
This function is used in parameter copy. The function codes that are
set (except the function codes for fault records F2-11 to F2-15) are
read and stored on the operation panel. "COPY" is displayed during
the reading, and "F4-00" is displayed after the reading is complete.
4: Parameter copy writing
This function is used in parameter copy. The values of the function
codes stored on the operation panel (except the function codes for
fault records F2-11 to F2-15) are written to the inverter. "PASTE" is
To Next Page
Loading...