MD280 User Manual Operation and Display
- 61 -
To perform reverse JOG, set F0-12 to 1. Hold down
MF.K
and the AC drive starts reverse JOG
running.
Note
If the reverse jog running cannot be implemented after setting F0-12 to 1, check and make sure
F5-09 is set to 0.
Ƶ
Parameter Setting and Operation of JOG Running in DI Terminal Control
)RUHTXLSPHQWWKDWUHTXLUHVIUHTXHQW -2*RSHUDWLRQVVXFKDVWH[WLOHPDFKLQHLWLVPRUH
FRQYHQLHQWWRFRQWURO-2*UXQQLQJ E\XVLQJNH\VRUEXWWRQV<RXQHHGWRLQVWDOO WZRH[WUD
buttons, namely FJOB and RJOG buttons, to realize such operation. To achieve convenient
FRQWUROSHUIRUPWKHVHWWLQJDFFRUGLQJWRWKHIROORZLQJ¿JXUH
Figure 4-14 JOG running in DI terminal control
F2-00
F2-01
F2-02
F2-03
F2-04
.
.
.
.
4
5
.
F0-00 1
JOG control
button
Terminal
Function
value
Setting
value
DI1
DI2
DI3
DI4
DI5
.
COM
Forward
JOG
Terminal
control
Parameter setting
Forward
JOG
Reverse
JOG
FJOG
RJOG
Reverse
JOG
F5-00 JOG running frequency
F5-01 JOG acceleration time
F5-02 JOG deceleration time
Forward
JOG
Reverse
JOG
Stop state
F5-09 1
$IWHUSHUIRUPLQJWKHVHWWLQJDFFRUGLQJWRWKHSUHFHGLQJ¿JXUHSUHVVWKH)-2*EXWWRQZKHQ
the AC drive is in stop state. Then, the AC drive starts forward JOG running. After you press
the FJOG button again, the AC drive decelerates to stop.
4.6 Setting the Running Frequency
The AC drive provides two frequency sources, namely, main frequency source X and
DX[LOLDU\IUHTXHQF\VRXUFH<<RXFDQVHOHFWRQHIUHTXHQF\VRXUFHDQGVZLWFKRYHUEHWZHHQ
the two sources. You can also perform superposition on the two sources by setting the
calculation formula to meet different control requirements of different scenarios.
4.6.1 Frequency Setting by the Main Frequency Source
7KHUHDUHVHWWLQJPRGHVRIPDLQIUHTXHQF\VRXUFHVGLJLWDOVHWWLQJWHUPLQDO83'2:1
$,$,SXOVHVHWWLQJPXOWLUHIHUHQFHVLPSOH3/&3,'FRPPXQLFDWLRQVHWWLQJ3,'$,
DQG3,'$,<RXFDQVHOHFWRQHLQ)
efesotomasyon.com