Inovance MD280NT2.2GB - Motor Setup and Terminal Usage

MD280 User Manual Operation and Display
- 69 -
Note

)'HVLJQDWHGFRXQWYDOXHPXVWQRWEHJUHDWHUWKDQ)6HWFRXQWYDOXH

DI5 must be used when the pulse frequency is high.

7KH'2WHUPLQDOWKDWLVDOORFDWHGZLWKIXQFWLRQ'HVLJQDWHGFRXQWYDOXHUHDFKHGDQGWKH'2
WHUPLQDOWKDWLVDOORFDWHGZLWKIXQFWLRQ6HWFRXQWYDOXHUHDFKHGPXVWQRWEHWKHVDPH

In the RUN/STOP state of the AC drive, the counter will not stop until "Set count value" is
reached.

The count value is retentive at power failure.

An automatic stop system can be implemented if the signal output by the DO terminal with the
IXQFWLRQ&RXQWYDOXHUHDFKHGLVIHGEDFNWRWKH',WHUPLQDORIWKH$&GULYHZLWKVWRSIXQFWLRQ
4.7 Setting and Auto-tuning of Motor Parameters
4.7.1 Motor Parameters to Be Set
The MD280 AC drive adopts V/F mode to drive the motor. Accurate motor parameters
are required to ensure desired driver performance and running efficiency. Set the motor
parameters according to the nameplate.
0RWRUSDUDPHWHUVPRWRUE\GHIDXOWWKDWQHHGWREHVHWDUHOLVWHGLQWKHIROORZLQJWDEOH
Table 4-2 Motor parameters to be set
Function Code Parameter Name Remarks
F1-00 Rated motor power
Model dependent,
manual input
F1-01 Rated motor voltage
F1-02 Rated motor current
F1-03 Rated motorf frequency
After setting the motor parameters correctly, set F1-18 to 1 to start static motor auto-tuning
to obtain the stator resistace of the motor automatically. For details, see the description of
F1-18.
4.7.2 Switchover Between Motor 1 Parameters and Motor 2 Parameters
The AC drive supports switchover between two groups of motor parameters, namely, group
))WR)DQGJURXS)&
You can select the current effective group of motor parameters by means of DI terminal with
function 32.
efesotomasyon.com