Inovance MD280NT2.2GB - Viewing Status Parameters

MD280 User Manual Operation and Display
- 55 -
)LJXUH([DPSOHRIFKDQJLQJWKHSDUDPHWHUYDOXH
50.00 F0 F1 F1-00 F1-06
F1 F1-07 015.00 010.00 010.00
PRG Ƹ
Enter
Ƹ
Ƹ
Enter
Ƹ
PRG
PRG
Enter
In Level III menu, if the parameter has no blinking digit, it means that the parameter cannot
EHPRGL¿HG7KLVPD\EHEHFDXVH
 Such a function code is only readable, such as, AC drive model, actually detected
parameter and running record parameter.
 6XFKDIXQFWLRQFRGHFDQQRWEHPRGL¿HGLQWKHUXQQLQJVWDWHDQGFDQRQO\EHFKDQJHG
at stop.
In the function code display state, select the required function code pressing
or .
4.3 Viewing Status Parameters
In the stop or running state, you can press on the operation panel to display status
parameters. Whether parameters are displayed is determined by the binary bits of values
FRQYHUWHGIURPWKHYDOXHVRI)DQG)LQWKHKH[DGHFLPDOIRUPDW
In running state, a total of 16 running status parameters can be displayed by default, set in
F7-13, as listed in the following table.
Function
Code
Parameter
Name
Setting Range Default
F7-13
LED display
running
parameters
1-65535
7 6 5 4 3 2 1 0
DO state
Output voltage V
DI state
Running frequency Hz
Bus voltage V
Output current A
Output power kW
Set frequency Hz
15 14 12 11 10 9 8
AI2 voltage V
PID setting
AI1 voltage V
PID feedback
13
Counted value
Pulse frequency Hz
Speed display
Length value
799
In stop state, a total of eight status parameters can be displayed, as listed in the following
table.
efesotomasyon.com