Inovance MD280NT2.2GB - Chapter 5 Function Code Table

Function Code Table MD280 User Manual
- 76 -
Chapter 5 Function Code Table
If FP-00 is set to a non-zero number, parameter protection is enabled. You must enter the
correct user password to enter the menu.
To cancel the password protection function, enter with password and set FP-00 to 0.
The symbols in the function code table are described as follows:
"
ƿ": T
he parameter can be modi¿ed when the AC drive is in either stop or running state.
"ƾ
7KHSDUDPHWHUFDQQRWEHPRGL¿HGZKHQWKH$&GULYHLVLQWKHUXQQLQJVWDWH
Ɣ7KHSDUDPHWHULVWKHDFWXDOO\PHDVXUHGYDOXHDQGFDQQRWEHPRGL¿HG
"*": The parameter is factory parameter and can be set only by the manufacturer.
Function
Code
Parameter Name Setting Range
Min.
Unit
Default
Property
Group F0: Basic Parameters
F0-00
Command source
selection
0: Operation panel control
LQGLFDWRU2))
7HUPLQDOFRQWUROLQGLFDWRU
21
2: Communication control
LQGLFDWRUEOLQNLQJ
10
ƿ
F0-01
Main frequency
source X selection
'LJLWDOVHWWLQJ83'2:1
PRGL¿FDWLRQ
1: AI1
2: AI2
3XOVHVHWWLQJ',
4: Multi-reference
5: Simple PLC
6: PID
$,$,
8: Communication setting
3,'$,
3,'$,
10
ƾ
F0-02
Retentive of digital
setting frequency
0: Not retentive
1: Retentive at power failure
2: Retentive at stop
3: Retentive at both power
failure and stop
10
ƿ
F0-03 Preset frequency
WRPD[LPXPIUHTXHQF\
)
0.01 Hz 50.00 Hz
ƿ
efesotomasyon.com