Chapter 6 Parameter Description
-53-
Chapter 6 Parameter Description
Group F0 Basic parameters
Control
mode
Factory default
value
0
0
Non-speed sensor
vector control
1
Reserved
F0-00
Setup
range
2
V/F control
0: None-speed sensor vector control (SVC)
refers to open-loop vector.
It is applicable to the general
high-performance control applications where
one inverter can only drive one motor. The
examples include machine tool, centrifugal
machine, wire drawing machine and injection
molding machine.
V/F control
It is applicable to the site with low
requirement for control precision, such as fan,
pump load. It can be used in the applications
where one inverter drives multiple motors.
Prompt: Motor parameter identification must
be conducted when selecting the vector
control mode. Refer to4.5 for details.
Command
Source
Selection
Factory
default
value
0
0
Operation panel
command channel
(LED OFF)
F0-01
Setup
range
1
Terminal command
channel (LED ON)
Select the channel for inverter control
command.
The inverter control command includes start,
stop, forward rotation, reverse rotation and
Jog.
0 Keypad control (“LOCAL/REMOT” LED
OFF)
Perform running command control with keys
on the keypad panel, such as RUN,
STOP/RES keys. If set multi-functional key
MF.K to FWD/REV switching function (set
F6-11 to 2), the running direction can be
changed by pressing the key.
1: Terminal control (“LOCAL/REMOT” LED
ON)
Perform running command control by the
multifunctional input terminals such as FWD,
REV, JOGF, JOGR, etc.
Main frequency
source X
selection
Factory
default
value
0
0
Digital setup UP
and DOWN
(without memory)
1
Digital setup UP
and DOWN (with
memory)
2
2: Pulse setup
(effective DI4
input )
3AI1
4
AI2
F0-02
Setup
range
5
MS speed
Select the input channel for main reference
efesotomasyon.com
To Next Page
Loading...
