Chapter 6 Parameter Description
-69-
Inverter load
lost protection
selection
Factory
default
value
1
F5-09
Setup
range˖
0: Disabled
1: Enabled
Select whether to
provide protection
for load loss. When
selecting load loss
protection and no
load is added to the
output end of
inverter, the output
frequency of
inverter will
automatically
reduced to 2Hz.
F5-10 Fault type
024
1
F5-11
Frequency
upon fault
Display the
frequency
upon fault for
the most
recent one
time.
F5-12
Current
upon fault
Display the
current upon
fault for the
most recent
one time.
F5-13
Bus
voltage
upon fault
Display the
bus voltage
upon fault for
the most
recent one
time.
Group F6 Auxiliary Function
maximum
output
frequency
Factory
default
value
50.0Hz
F6-00
Setup
range
50.00Hz300.00Hz
It is used to set the maximum output
frequency of inverter.
Frequency
upper limit
Factory
default
value
50.0
Hz
F6-01
Setup
range
frequency lower limit
F0-11 to maximum
frequency F6-00
Upper limit of inverter output frequency
Frequency
lower limit
Factory
default
value
00.0Hz
F6-02
Setup
range
0.00H] upper limit
F6-01
When the inverter starts to run, the inverter
will not output if the reference frequency is
less than the lower limit frequency. During the
running process, if the reference frequency is
less than the lower limit frequency, the inverter
will keep running at the lower limit frequency
until the stop of the inverter or the reference
frequency over lower limit frequency.
Carrier
freque
ncy
Factory
default
value
Model
dependent
F6-03
Setup range :0.5kHz to 16.0kHz
This function is used to adjust the carrier
frequency of the inverter. By adjusting the
carrier frequency, the motor noise can be
efesotomasyon.com
To Next Page
Loading...
