Inovance MD300 Series - Group FF Factory Parameters (Reserved); Group FP User Password

Chapter 7 EMC (Electromagnetic Compatibility)
-73-
Group FF Factory Parameters (Reserved)
Group FP User Password
user password
Factory default value
0
FP-00
Setup range
065535
Any non-zero number can be set, and then the password protection function will be enabled.
0000Password protection function disabled
Upon setup and validation of the user password, when the user enters the parameter setting
status again, the user can view the parameters only and cannot modify the parameter if the
password is incorrect. Please remember the setup user password correctly. If the
password is set wrongly or forgotten, please contact the manufacturer.
Parameter initialization
Factory default value
0
0
No operation
1
Restore the factory default setup value
FP-01
Setup range
2
Clear the fault record
1The inverter will recover all parameters to the factory default ones.
2: The inverter clears the recent fault records.
efesotomasyon.com