Inovance MD300 Series - Page 74

Chapter 6 Parameter Description
-72-
remote operation.  It refers to switching of
command source, switching from the current
command source to the keyboard control
(local operation).  If the current command
source is keyboard control, this command is
disabled.
2: Switching between forward rotation and
reverse rotation
It can switch the direction of the frequency
command via the MF.K key on the keyboard.
It is enabled only in the operation panel
command channel.
3: Forward rotation Jog
It can realize forward rotation Jog (FJOG) via
the MF.K key on the keyboard.
STOP/RESET
key function
Factory
default
value
0
0
STOP key disabled
in the terminal
control mode
F6-12
Setup
range
1
STOP key enabled
in the terminal
control mode
The RESET function is enabled in all
statuses.
Earth short
circuit
protection
detection
upon
power-on
Factory
default
value
1
F6-13
Setup
range
0: Disabled
1: Enabled
It can select whether the inverter checks the
motor for earth short circuit failure upon
power-on. If this function is enabled, the
inverter has short-time output at the instance
of power-on.
MS
speed 0
Factory
default value
0.0
Hz
F6-14
Setup
range
Negative maximum
frequency to
maximum frequency
MS
speed 1
Factory
default value
0.0
Hz
F6-15
Setup
range
Negative maximum
frequency to
maximum frequency
MS
speed 2
Factory
default value
0.0
Hz
F6-16
Setup
range
Negative maximum
frequency to
maximum frequency
MS
speed 3
Factory
default value
0.0
Hz
F6-17
Setup
range
Negative maximum
frequency to
maximum frequency
When selecting MS speed as frequency
source (F0-02=5), it is required to set the
value from F6-14 to F6-17.
heatsink
temperat
ure
Factory
default
value
1ć
F6-18
Setup
range
0ć
150ć
Display
heatsink
temperature
F6-19
Software
version
No.
Factory
default
value
Version
No. of
current
software
efesotomasyon.com