Inovance MD300 Series - Page 66

Chapter 6 Parameter Description
-64-
2: Three-line running mode : In this mode, Dln
is enabled terminal, and the direction is
controlled by FWD and REV respectively.
However, the pulse is enabled through
disconnecting the signal of Dln terminal when
the inverter stops.
Fig.6-4 Three-line Running Mode
Where,
SB1 Stop button SB2: FWD button
SB3: REV button
Din is the multifunctional input terminal of DI1
to DI4. In this case, the function of the
corresponding terminal shall be defined as
“three-line running control”.
Prompt: For two-line operation mode, when
FWD/REV terminals are enabled and the
inverter stops due to the command from other
sources, the inverter will not operates after the
canceling of the stop command even though
the control terminals FWD/REV are still
enabled. Retrigger FWD/REV will make the
inverter run. Such as the valid STOP key in
the operation command channel (See F6-12).
However, if the inverter stops when fault alarm
occurs, the running of the inverter is controlled
by function code F6-09.
Terminal
UP/DOWN
Speed
Factory
default
value
1.00
Hz/s
F3-01
Setup
range
0.01Hz/s100.00Hz/s
Terminals UP/DOWN is used to adjust the
change rate when setting the frequency.
AI
minimum
input
Factory
default
value
0.00V
F3-02
Setup range
0.0010.00V
AI
minimum
input
correspon
ding setup
Factory
default
value
0.0%
F3-03
Setup range
-100.0%100.0%
AI middle 1
input
Factory
default
value
5.00V
F3-04
Setup range
0.00V10.00V
AI middle 1
input
correspon
ding setup
Factory
default
value
50.0%
F3-05
Setup range
-100.0%100.0%
AI middle 2
input
Factory
default
value
8.00V
F3-06
Setup range
0.00V10.00V
AI middle 2
input
correspon
ding setup
Factory
default
value
80.0%
F3-07
Setup range
-100.0%100.0%
AI
maximum
input
Factory
default
value
10.00
V
F3-08
Setup range
0.00V10.00V
efesotomasyon.com