Inovance MD300 Series - Page 88

Chapter 8 Troubleshooting and Countermeasures
-86-
External equipment fault
If it is stopped by pressing the STOP key
in the non-keyboard operation mode
Reset to run
If it inputs external fault signal via
the multifunctional terminal DI
Check and remove
the external fault
Stop the unit with the key STOP
under stall condition
Reset to run
No
No
Yes
Yes
Yes
Fig.8-14 External Equipment Fault˄ERR15˅
Current detection fault
Check if the hall device is normal
Replace the hall device
Detect if the drive board is normal
Replace the drive
board
Ask for technical support
No
No
Yes
Fig.8-15 Current detection fault˄ERR18˅
efesotomasyon.com