Maintenance and Inspection
‑170‑
Note
● Install the fan in the reverse order of removal and ensure the correct direction of
the fan.
● The fan should rotate clockwise to blow air into the motor air duct when viewed
from the rear cover of the fan.
1. Plug the fan power cable
connector to the socket.
2. Install the fan into the drive,
with the four fixing holes at the
bottom of the fan aligned with
the positioning pins.
3. Insert the two small snap‑fit
joints on the fan cover into the
slot and then press down to fix
the snap‑fit joints.
To Next Page
Loading...
