Options
‑71‑
Note
● The bottom installation bracket applies to the PS standard cabinet, which is
classified into two types: 800 mm (width) x 600 mm (depth) and 800 mm (width) x
800 mm (depth). The size described in the figure applies to the PS standard
cabinet with 800 mm (width) x 800 mm (depth).
● The bottom installation bracket for T10 to T12 models applies only to the PS
standard cabinet with 800 mm (width) x 600 mm (depth). To apply to the PS
standard cabinet with 800 mm (width) x 800 mm (depth), contact Inovance.
5.2.4 Guide Rail
For details of the guide rail, see
Operation Instructions for MD500‑AZJ‑A3T10 Guide
Rail
.
5.2.5 Installing the U/V/W Copper Busbar
All MD520 models excluding those with the base (‑L) are delivered with U/V/W output
side copper busbars. To install the U/V/W output copper busbars, follow the steps
below:
1. Use the screwdriver or cutting pliers to remove the three knockouts.
2. Use the four plastic snap‑fit joints in the packing box to fasten the insulating paper
to the chassis through the four holes on the paper.
To Next Page
Loading...
