Certification and Standard Compliance
‑188‑
Terminal dimensions and cable selection
For selection of terminals and cables for main circuits, see "
5.3.1 Main Circuit Cables
"
on page 73
.
Requirements for protective devices
● To comply with UL standards, install a fuse/circuit breaker on the input side of the
drive to prevent accidents caused by short circuit in the internal circuit.
● Install sufficient protective devices against short circuit in branch circuits
according to applicable regulations and this guide. The drive is applicable to
circuits with a rated breaking capacity lower than 100000 A and a maximum
voltage of 480 VAC (class 400 V). For selection of circuit breakers, see "
5.4.1 Fuse,
Contactor, and Circuit Breaker
"
on page 86
.
8.4 KCC Certification
8.5 Function Safety Certification
EU directives and standards
Low Voltage Directive 2014/35/EU, EN 61800‑5‑1
To Next Page
Loading...
Need help?
General