Certification and Standard Compliance
‑182‑
● The drive complies with LVD, EMC, and RoHS directives and carries the CE mark.
● The machinery and devices equipped with this product must also meet CE
requirements when sold in Europe.
● The integrator who integrates this product with other devices has the
responsibility of ensuring compliance with CE standards when the CE mark is
labeled on the final device.
8.2.2 Requirements for Compliance with EMC Directive
● The drive is applicable to the first environment and second environment and
complies with EMC directive 2014/30/EU and standard EN IEC 618003.
If the product is used in the first environment, it may generate radio interference. In addi‑
tion to CE compliance requirements, measures should be taken to prevent interference
when necessary.
● To enable the drive to comply with the EMC directive and standards, install an
EMC filter on the input side and use shielded cables on the output side. Ground
the filter properly. Ground the shield of the output cable in 360 degrees.
The manufacturer of the system with the product installed must ensure that the system
meets the requirements of the European EMC Directive, and ensure that the system meets
the requirements of the standard EN IEC 61800‑3 according to the application environment
of the system.
EMC specifications
The drive complies with EN IEC 61800‑3. The maximum length of the motor cable
allowed by the conducted and radiated emission is shown in the following table.
To Next Page
Loading...
