Installation
‑72‑
Type
Mark
Name
Function Description
Auxiliary ports
J13
Expansion
card terminal
It is a 28‑conductor terminal used
to connect optional cards, such as
bus cards
J4
PG card
terminal
It is used to connect the resolver,
differential, and 23‑bit encoders.
J11
Port for
external
operating
panel
It is used to connect the LCD
operating panel (SOP‑20) and the
LED operating panel (MDKE‑10).
DIP switches
S1
For details, see "
Table 5–16
Description of control circuit
terminals 2
"
on page 72
.
S2
For details, see "
Table 5–16
Description of control circuit
terminals 2
"
on page 72
.
S3
For details, see "
Table 5–16
Description of control circuit
terminals 2
"
on page 72
.
S4
It is used to determine whether
AO1 supports the current mode. If
S4 is closed, AO1 supports the
current mode.
Table 5–16 Description of control circuit terminals 2
DIP Switch
Description
Mark
S1 S2 S3
Name OFF OFF OFF
Voltage mode for AI2
ON OFF OFF
Temperature mode
for AI2. The
temperature sensor
type can be set by F9‑
57.
OFF ON OFF
Current mode for AI2
with the input
impedance 500 Ω
OFF ON ON
Current mode for AI2
with the input
impedance 250 Ω
To Next Page
Loading...
