Certification and Standard Requirements
‑101‑
The default setting of the drive shall enable the user to get started and check the
basic mechanical operation condition quickly. The user can later perform fine tuning
to optimize the operation/performance.
Parameter adjustment shall be completed by qualified personnel trained on servo
drives. Some parameter settings may cause failures if you operate improperly,
especially during commissioning start‑up. Prevent any person from touching the
equipment.
This manual provides a complete list of parameters and functional descriptions,
which should always be adjusted with care during field start‑up. If in doubt, please
contact Inovance and authorized distributors for technical support.
To Next Page
Loading...
