Inovance SV670P Series User Manual

Terminals
‑70‑
Analog output signal
The output terminal for analog speed and torque signals is AO1, supporting a voltage
range of –10 V to +10 V. The voltage value is set in group H04.
4.2.4 DI/DO Signals
For description of DI/DO signals, see " Table 4–8 " on page 59 .
DI circuit
The circuits for DI1 to DI8 are the same. The following takes the DI1 circuit as an
example.
● The host controller provides relay output.
■ For use of the internal 24 V power supply of the servo drive:

Inovance SV670P Series Specifications

General

Brand	Inovance
Model	SV670P Series
Category	Servo Drives
Language	English