‑12‑
General Safety Instructions
● Dynamic braking is common in rotating mechanical structures. For example, when
a motor has stopped running, it keeps rotating due to the inertia of its load. In this
case, this motor is in the regenerative state and short‑circuit current passes
through the dynamic brake. If this situation continues, the drive, and even the
motor, may be burned.
Safety Label
For safe equipment operation and maintenance, comply with the safety labels on the
equipment. Do not damage or remove the safety labels. See the following table for
descriptions of the safety labels.
Safety Label Description
● Never fail to connect the protective earth (PE) terminal. Read
through the guide and follow the safety instructions before use.
● Never fail to connect Protective Earth (PE) terminal. Read the manual
and follow the safety instructions before use.
● Do not touch terminals within 15 minutes after disconnecting the
power supply to prevent the risk of electric shock.
● Do not touch terminals with 15 minutes after Disconnect the power.
Risk of electrical shock.
● Do not touch the heatsink with power ON to prevent the risk of burn.
● Do not touch heatsink when power is ON. Risk of burn.
To Next Page
Loading...
