13
L-Shaped Computer Desk
www.insigniaproducts.com
STEP 7: Connect the left and right hutch panels to the hutch assembly
You n e ed:
1 To connect the left hutch panel (5) to the hutch assembly, align the wooden dowels and cam-lock screws with the
holes in the panels.
2 Insert four cam locks (C) into the hutch assembly (as shown). Make sure that the cam lock arrows are pointing
toward their corresponding cam-lock screw holes.
3 Turn the cam locks clockwise with a Phillips screwdriver until they are fully tightened (about 160° to 185°).
4 Cover the four cam locks on the bottom hutch panel (3) with screw covers (G).
5 Repeat steps 1–3 to connect the right hutch panel (6).
T
C
Cam locks (8)
Phillips screwdriver
5
Left hutch panel
6
Right hutch panel
G
Screw covers (4)
To Next Page
Loading...
Need help?
General
