24
www.insigniaproducts.com
STEP 18: Secure your desk to the wall
You n e ed:
1 Move your desk where you want to place it. The hutch should be against a wall.
2 Find the anchor holes in the hutch’s back panel, then mark their location on your wall with a pencil.
3 Move your desk away from the wall.
4 Drill two M8 (7.1 mm) holes in the wall at the places you marked with a pencil.
5 Insert the anchors (H) into the holes and gently tap them with a hammer until they are flush with the wall.
6 Push your desk back against the wall, then secure with two 5 × 50 mm screws (K) and a Phillips screwdriver.
7 Cover the heads of the screws with the screw covers (G).
WARNING:
• DO NOT SKIP THIS STEP. Securing your desk protects children and pets from accidental tip-overs and injury.
•The included screws (K) and anchors (H) are intended for securing your desk to drywall only. If your wall is made of a different
material, you must purchase appropriate anchors and screws separately.
H
Anchors (2)
Drill with M8 bit
(For wall mounting only)
HammerPhillips #2 screwdriver
K
5 × 50 mm screws (2)
G
Screw covers (2)
Pencil
To Next Page
Loading...
