Insignia NS-ODL3 - STEP 10: Connect the Hutch Assembly to the Main Desktop

16
www.insigniaproducts.com
STEP 10: Connect the hutch assembly to the main desktop
You n e ed:
1 Insert two wooden dowels (A) into the bottom edges of the left hutch panel (5) and right hutch panel (6).
2 Align the wooden dowels and screw holes in the hutch assembly with the holes in the main desktop (7).
3 Secure the main desktop with four 5 × 50 mm screws (K) and a Phillips screwdriver.
Phillips screwdriverK
5 × 50 mm screws (4)
7
Main desktop
A
Wooden dowels (2)