20
www.insigniaproducts.com
STEP 14: Connect the main leg assembly and side leg assembly
You n e ed:
1 Align the bottom support bar (13) connected to the main leg assembly with the bracket on the center leg (16),
then secure with two M6 × 15 mm bolts (J) and a hex wrench (M).
2 Align the main back support bar (11) with the holes at the top of the center leg (16), then secure with two
M6 × 15 mm bolts (J) and a hex wrench (M).
3 Align the end of the main front support bar (12) with the hole on the side front support bar (15), then secure with a
M6 × 50 mm bolt (L) and a hex wrench (M).
Note: To make assembly easier, do not lock the bolts tightly until you have assembled all other parts.
L
M6 × 50 mm bolt
J
M6 × 15 mm bolts (4)
M
Hex wrench
To Next Page
Loading...
