23
Site requirements
Product Support: www.instron.com
Instron is responsible for insurance cover while the testing system is in the factory up
until it reaches the loading dock for shipping.
Installation
When the site location is prepared and the frame and its components have been moved
to the final operating location (refer to “Lifting and handling” on page 49), Instron
®
is
responsible for the complete installation of the load frame, its components and any
additional accessories that may have been purchased.
The customer must not make any attempt to install the load frame without an Instron
®
service representative present.
Initial operation
Once the installation is complete, Instron
®
performs an initial operation of the load
frame and a calibration check to ensure that it is working properly.
The service representative also performs a required on-site training program. The
required on-site training takes approximately one day to complete, and is designed to
accommodate up to three individuals.
Contact Instron
®
Service for more information on this training. Additional training is
available through Instron’s training center.
Documentation
Instron
®
provides all the documentation required to operate the system, including
manuals for the load frame and any required online help systems for software
applications.
Additional copies of manuals are available and can be ordered through the Instron
®
Sales department.
Site requirements
Proper site preparation is imperative so that the testing system operates in accordance
with its specifications.
To Next Page
Loading...
Need help?
General
