125
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Note:
When Zone 2 is turned off, the output from the 12V
TRIGGER OUT goes low (0 volts).
Controlling Zone 2 with the Remote
Controller
Note:
To control Zone 2, you must press the remote control-
ler’s [Zone2] button first.
The Zone2 button turns red while Zone 2 is on.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the Zone 2 indicator
lights up.
Tip :
The 12V TRIGGER OUT goes high
(+12 V).
To select AM or FM press the [Tuner]
input selector and the [Zone 2] button
repeatedly. You can also select SIRIUS
(North American models).
To select the same source as that of the
main room, press the [Zone 2] button
twice. “Zone 2 Selector: Source”
appears on the display.
2
To turn off Zone 2, press the
[Zone 2] button.
The Zone 2 indicator flashes.
Press the [Off] button.
The zone is turned off, and the Zone 2
indicator goes off.
Zone 2
Off
Input selector buttons
Zone 2 indicator
1
Press the [Zone2] button, then
point the remote controller at the
AV receiver and press the [On]
button.
Tip :
The 12V TRIGGER OUT goes high
(+12 V).
2
To select an input source for
Zone 2, press the [Zone2] button,
followed by an Input Selector
button.
To select AM or FM press the [Tuner]
Input Selector
and the [Zone2] button
repeatedly. You can also select SIRIUS
(North American models).
3
To turn off Zone 2, press the
[Zone2] button, followed by the
[Standby] button.
Input
Selector
On
Zone2
Standby
To Next Page
Loading...
Need help?
General
