40
Turning On the AV receiver
On/Standby
Standby
On
Receiver
Standby indicator
Turning On and Standby
On the AV receiver, press the [On/Standby] button.
On the remote controller, press the [Receiver] button, followed by the
[On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller’s [On] button again will turn on any components
connected via u.
To turn the AV receiver off, press the [On/Standby] button, or press the remote
controller’s [Standby] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you turn on the AV receiver, always turn down the volume before
you turn it off.
or
Remote
controller
AV receiver
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Run MultEQ Room Correction and Speaker Setup—this is
essential!
See “Audyssey MultEQ
®
Room Correction and Speaker Setup” on
page 50.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 44, “Component Video
Setup” on page 45, or “Digital Audio Input Setup” on page 46
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 49.
HDMI
OUT IN
TV/TAPE
MD recorder, CD recorder,
RI Dock
To Next Page
Loading...
Need help?
General
