EasyManua.ls Logo

Integra DTR-80.2 - Using Zone 2;3;4; Controlling Zone 2;3;4 from the AV receiver

Integra DTR-80.2
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
87
En
Zone 2 Power On Volume,
Zone 3 Power On Volume,
Zone 4 Power On Volume
` Last, Min, 1 to 99 or Max (Absolute display)
` Last
, QdB, –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2/3/4 each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was
last turned off, select “Last”.
The “Zone 2 Power On Volume”, “Zone 3 Power On
Volume” and “Zone 4 Power On Volume” cannot be set
higher than the “Zone 2 Maximum Volume”, “Zone 3
Maximum Volume” and “Zone 4 Maximum Volume
setting.
Zone 2 Component Out
` Use:
Select if a TV in Zone 2 is connected the COMPO-
NENT VIDEO ZONE 2 OUT.
` Not Use:
Select if no TV in Zone 2 is connected the COMPO-
NENT VIDEO ZONE 2 OUT.
If you’ve connected the COMPONENT VIDEO ZONE 2
OUT to a TV in Zone 2, this setting is set to “Use”.
Note
If the “Zone 2 Component Out” setting is set to “Not
Use”, the same video signal as COMPONENT VIDEO
MONITOR OUT is output from ZONE 2 OUT (compo-
nent).
This section explains how to turn Zone 2/3/4 on and off,
how to select an input source for Zone 2/3/4, and how to
adjust the volume for Zone 2/3/4.
Controlling Zone 2/3/4 from the AV receiver
Note
When Zone 2/3/4 is turned off, the output from the 12V TRIG-
GER OUT goes low (0 volts).
Using Zone 2/3/4
1
To turn on Zone 2/3/4 and select an input source,
press Zone 2, Zone 3 or Zone 4 followed by an
input selector button within 8 seconds.
Zone 2/3/4 turns on, the Zone 2/3/4 indicator lights.
Tip
•The 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2, Zone 3 or Zone 4 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press Zone 2, Zone 3 or Zone 4 twice. “Zone2
Selector: Source”, “Zone3 Selector: Source” or
Zone4 Selector: Source” appears on the display.
2
To turn off Zone 2/3/4, press Off for each Zone.
The zone is turned off, and the Zone 2, Zone 3 or
Zone 4 indicator goes off.
Zone 3
Zone 2
Zone 4
Off
Zone 2 indicator
Zone 4 indicator
Input selector buttons
Zone 3 indicator

Table of Contents

Related product manuals