Intek KT-355EE - Paging System Preparation; Paging Requirements and Code Setup; Code Address Number Mapping

Paging Operation
n This function tan be used to page individual stattons (per-
n Code address numbers and their functions
sonal pagtng) or a spectftc group of stations (group pag-
ins).
(1) The Pagfng funcbon requires that the sending and recew!ng
ends use matthing personal or group paging Codes. The
same group code must be used by every member of the
group
Preparations for paging
n You must perform the followtng Steps before you tan use
the pagtng functton
1) Decide on your own personal code and record tt tn
memory at code address number 0
2) Decide on the other Codes you WIII use (personal Codes
of other Stattons or group Codes) and record them tn
memory at code address numbers 1 = 8
3) Indtcate the code address numbers between 1 - 8
whtch you wsh to use as group code address numbers
durtng recephon wth the - (decode mark) Symbol
(See the sectton describtng the method for destgnattng
code address numbers as group Codes for recetwng )
t
i
Memory
address
Pagtng functton (the Code setbng and your personal
number
code setttng are broadcast )
The personal Code 01 the Statton called IS
automatrcally recorded at this address
The personal Code of the other Statton IS
P
automatlcally recorded m memory and appears on
the display
if you press the PTT button at this potnt. the code
being dtsplayed IS transmttted
Thts IS the memory address for your personal code
When you arc called wth your personal Code. the
0
personal Code of the other statlon (memory address
0) appears on the display
If you press the PTT button at this polnt. the Code
being dtsplayed IS transmttted
1
These memory addresses arc for the personal
2
Codes of other Stattons and group Codes
3
Group Codes deslgnated wth the - mark tan be
4
used for recetwng
5
6
The -
mark 1s the decode mark
7
8
The - mark tan be asslgned to more than one
memory address
,
L
21