Intek KT-355EE - Scan Operation Modes Explained; Overview of Scan Types; Available Scan Function Categories; Scan Function Interaction Notes

Scan ODeration
Scan types
n There are three scan types to choose from pause scan,
busy scan and hold scan
Independent of the above three scan types, the mrcropro-
cessor automattcally determrnes the scan Speed (tntelligent
scan functton) based on factors such as the amount of fre-
quency variabon whether T SC IS on or off. etc
(1) Pause scan
Scan pauses when a Signal IS recerved Five seconds later.
scan Operation recommences even if a srgnal IS still berng
received (If the Signal is lost in less than five seconds,
scan recommences immediately )
(2) Busy scan
Scan IS paused for as lang as a Signal IS berng recetved.
Scan operatlon recommences two seconds after the Signal
IS lost.
l 1
I
8
(3) Hold scan
k-D~spiayed cont~nuously
Scan is temporarily suspended when a Signal IS received.
Pressing the A IV kevs Causes scan operabon to recom-
mence.
Scan functions
(1) VFO scan
1) Scanntng the 1 MHz range of your chotce [l MHz scan]
2) Scanmng an entere band (Full band scan]
3) Scanning a range of frequencres specifted by you
[Program scan]
(2) Memory scan
1) Scanning all memory addresses stored an memory
[Memory scan]
2) Scanntng a memory address block specified by you
[Block memory scan]
3) Scannmg memory addresses specrfred by you
[Memory scan memory]
(1) If fhe save function is on, save memory scan Operation wfll
result
(2) If fhe save function is on and a scan type other fhan memory
scan is initlated, the save function is suspended.
(3) Tone frequency scan
1) Scans the tone frequencres
The optional CTCSS untt is requtred
1 sr Flashes
(1) The scan type tan be changed even while a scan IS in
progress. (See page 38 for details.)
34