Intek KT-355EE - Clone Mode Operation for Data Transfer

Clone mode
n This functlon allows you to copy the contents of your trans-
cetver’s memory to the memory of another transcelver
“sing DTMF Codes
H A maximum of approximately four minutes IS requlred for
coww
1) Swtch to the set mode
2) Hold down the FUNC key and press the 7 T SQ DM key.
No Pep (short high pltched beep) Sounds. The clone
mode IS actlvated.
3) Press the PTT swtch to transmit the contents of the
transcewer’s memory as DTMF Codes.
If such a transmission IS recelved while In the clone
mode, your transcelver’s memory IS overwrltten wlth the
data received
4) When receiving (transmission) IS finished, the unit
returns to the normal operatlng mode
(1) While clone mode is actwe, rf you perform another Operation
an the gaps between when DTMF Signals recelved (or sent).
clone mode is canceled automatully.
(2) The conVol keys do not function wh//e recelvfng (or sending)
in the clone mode.
(3) If the power swltch is turned off while recewmg (or sending)
,n the clone mode. the unit’s proper operatfon cannot be
guaranteed.
(4) The unlt’s proper Operation cannot be guaranteed if the con-
tents of memory were not copied correctly and complerely.
53