Intek KT-355EE - DTMF Operation Basics; DTMF Memory Functionality; DTMF Memory Display and Input Procedure

DTMF Operation
DTMF memory function DTMF memory display
n You tan store strings of up to 15 characters Including
0 - 9, A - D, +k and # in memory for later
transmission as DTMF Codes.
1) Hold down the FUNC kev and oress the SQL OFF key
n There are 10 DTMF memory address numbers num-
bered 0 - 9
(1) DTMF memory display
The last DTMF memory address number used is dis-
played. (The DTMF memory address number IS set to 0
when the unit IS shipped from the factory.) Block one is
displayed.
\MW
Block 1
Block 2 Block 3
2)
n The 15 column DTMF memory address numbers are
each divided Into three blocks of frve columns.
n The blocks tan be drsplayed one at a time
The block indicator Shows which block, 1, 2 or 3. IS
being displayed.
3)
4-l
Select the desired DTMF memory address number usrng
the rotary channel selector. A puff (short low prtched
beep) Sounds at DTMF memory address number 0.
The A iV keys cannot be used to select DTMF memory
address numbers because they are used as the C and D
keys for this function.
Input the code to be stored in memory usrng the
numeric keys The 8 Character IS drsplayed as an [E]
and the # as an [Fl.
When Input is frnished, hold down the FUNC key and
press the B V/M ENT key.
The code IS stored rn memory If you Input a code a full
15 characters lang, a peep (lang high pttched beep)
display, hold down the FUNC key and press the
SQL OFF key
43