Intek KT-355EE - DTMF Code Management; Transmitting Stored DTMF Codes; Deleting DTMF Memory Entries

(1) DO not perform step 4) above if you input a code a full 75
characters lang.
Transmitting DTMF memory Codes
Performing step 4) in th!s case will delete the code from
memory.
(1) You’can move the cursor by holding down the FUNC key
and presslng the A /y key.
;i
3)
Press the PTT swltch
With the PTT switch held down, press SQL OFF to blank
the frequency display. (DO not press the FUNC key )
With the PTT switch still heid down, press the numeric
key corresponding to the DTMF memory code you wish
to transmit.
(2) While the cursor move to a digit, the digit will be flash-
ing and you tan enter the new digit to Change as you
Want.
The DTMF memory code you selected IS transmitted and
appears on the display
(3) After Change, hold down the FUNC key and press the
B V/M ENT key. The new code will be stored in memory.
Deleting DTMF memory address
number entries
-
4)
Release the PTT swltch
Select the DTMF memory address number you wish to
delete using the rotary channel selector
Conflrm that the leftmost digit of block one is flashing
If not. hold down the FUNC key and press the A /v key
as appropriate to Cause the leftmost digit of block one to
flash
Hold down the FUNC key and press the B VIM ENT key
A peep (long high pitched beep) Sounds and the code IS
erased from memory. The display changes as follows.
(1) Besure to keep the PTT swltch held down unhl step 3) above
IS hnfshed
(2j Once transmissfon of the DTMF memory code begms. the
PTT swftch tan be released wlth no III effects
(The full DTMF memory Code WI// be sent regardless)
44