Intek KT-355EE - Paging Communication Control; Advice on Code Matching and Station ID; Resuming Normal Communication Post-Page

(1) If !he Codes match, the unit drsplays the contents of code (1) If the C 7 PAG key is pressed wrth the FUNC key held
address P, rndicating that you have been paged using your down whrle the PAG rndication IS flashmg, PAG drsappean
personal code If somethrng other than code address P and the rndication 1 remains
appears. you have been paged usrng a group code Thts means that the PAG functton is temporarily sus-
(2) The personal code of the calling statron IS recorded at code pended
3)
m
address P even rf you are paged using a group Code.
By checktng code address P you tan determtne whrch
member of the group is callrng.
Communicating after Codes match
If the Codes match, switch the PAG functton off and commu-
ntcate normally.
(2) Normal communrcation IS possrble when the 1 mdrcatton
IS drsplayed. ]ust as rf step 1) at left had been performed
However, rn thrs Status the mtcfoprocessor still considers
the paging function to be on. So if you turn the power off
and then on, or Change the frequency, PAG will reappear
on the display
1) Hold down the FUNC key and press the C 7 PAG key
twice.
The display indtcation changes from PAG B to CSQ to
nothing. Thrs indicates that the PAG function IS off.
Continue with normal communication.
26