8XC251SA, SB, SP, SQ USER’S MANUAL
11-6
The power off flag (POF) in the PCON register indicates whether a reset is a warm start or a cold
start. A cold start reset (POF = 1) is a reset that occurs after power has been off or V
CC
has fallen
below 3 V, so the contents of volatile memory are indeterminate. POF is set by hardware when
V
CC
rises from less than 3V to its normal operating level. See section 12.2.2, “Power Off Flag.”
A warm start reset (POF = 0) is a reset that occurs while the chip is at operating voltage, for ex-
ample, a reset initiated by a WDT overflow or an external reset used to terminate the idle or pow-
erdown modes.
11.4.1 Externally Initiated Resets
To reset the 8XC251Sx, hold the RST pin at a logic high for at least 64 clock cycles (64T
OSC
)
while the oscillator is running. Reset can be accomplished automatically at the time power is ap-
plied by capacitively coupling RST to V
CC
(see Figure 11-1 and section 11.4.4, “Power-on Re-
set”). The RST pin has a Schmitt trigger input and a pulldown resistor.
11.4.2 WDT Initiated Resets
Expiration of the hardware WDT (overflow) or the PCA WDT (comparison match) generates a
reset signal. WDT initiated resets have the same effect as an external reset. See section 8.7,
“Watchdog Timer,” and section 9.3.5, “PCA Watchdog Timer Mode.”
11.4.3 Reset Operation
When a reset is initiated, whether externally or by a WDT, the port pins are immediately forced
to their reset condition as a fail-safe precaution, whether the clock is running or not.
The external reset signal and the WDT initiated reset signals are combined internally. For an ex-
ternal reset the voltage on the RST pin must be held high for 64T
OSC
. For WDT initiated resets, a
5-bit counter in the reset logic maintains the signal for the required 64T
OSC
.
The CPU checks for the presence of the combined reset signal every 2T
OSC
. When a reset is de-
tected, the CPU responds by triggering the internal reset routine. The reset routine loads the SFRs
with their reset values (see Table 3-5 on page 3-17). Reset does not affect on-chip data RAM or
the register file. However, following a cold start reset, these are indeterminate because V
CC
has
fallen too low or has been off. Following a synchronizing operation and the configuration fetch,
the CPU vectors to address FF:0000. Figure 11-5 shows the reset timing sequence.
To Next Page
Loading...
Need help?
General
