Intel Desktop Board CA810E Product Guide
22
How to Install and Remove the Desktop Board
Refer to your chassis manual for instructions on installing and removing the desktop board. On a
microATX chassis, the desktop board is secured to the chassis by eight screws. Figure 3 shows the
locations of the mounting screw holes. On a standard ATX chassis, the desktop board is secured to
the chassis by seven screws and the provided standoff (see Figure 4).
✏
NOTES
You will need a Philips (#2 bit) screwdriver.
Refer to Appendix B for regulatory requirements and installation instructions and precautions.
WARNING
This procedure should be done only by qualified technical personnel. Disconnect the computer
from its power source before doing the procedures described here. Failure to disconnect the
power before you open the computer can result in personal injury or equipment damage.
OM08908
Figure 3. Locations of the Mounting Screw Holes
To Next Page
Loading...
