Intel Desktop Board DG41TY Product Guide
14
The Desktop Board supports the memory configurations listed below:
• Four 240-pin Double Data Rate 2 (DDR2) SDRAM Dual Inline Memory Module
(DIMM) connectors with gold-plated contacts
• Support for:
⎯ Non-ECC, 1.8 V, DDR2 800/667 MHz memory
⎯ Serial Presence Detect (SPD) memory only
⎯ Unbuffered, non-registered single- or double-sided DIMMs
⎯ Memory configurations listed below:
• Up to 2.0 GB utilizing 256 Mb technology
• Up to 4.0 GB utilizing 512 Mb or 1 Gb technology
• A minimum of 512 MB of total memory is required
NOTE
System resources and hardware (such as PCI Express) require physical memory
address locations that can reduce available addressable system memory. This could
result in a reduction of as much as 1 GB or more of physical addressable memory
being available to the operating system and applications, depending on the system
configuration and operating system.
Go to the following locations for more information about:
• SDRAM specifications, http://intel.com/technology/memory/
• Installing memory, page 36 in Chapter 2
• Tested memory, http://cmtlabs.com/mbsearch.asp
Intel
®
G41 Express Chipset
The Intel G41 Express Chipset consists of the following devices:
• Intel G41 Express Chipset Graphics and Memory Controller Hub (GMCH) with Direct
Media Interface (DMI)
• Intel 82801G I/O Controller Hub (ICH7) with DMI
The GMCH component provides interfaces to the processor, memory, PCI Express, and
the DMI interconnect. The component also provides integrated graphics capabilities
supporting 3D, 2D, and display capabilities. The ICH7 is a centralized controller for
the board’s I/O paths.
Related Links:
Go to the following link for more information about the Intel G31 Express Chipset:
http://developer.intel.com/products/chipsets/index.htm
To Next Page
Loading...
Need help?
General
