Intel E810-CQDA2T - Page 15

722960-002 15
Intel
®
Ethernet Network Adapter E810-CQDA2T
User Guide
5. Power cycle the system and check correct driver and NVM version:
#ethtool -i ens801f0
driver: ice
version: 1.12.7
firmware-version: 4.31 0x8001af21 1.3429.0
expansion-rom-version:
bus-info: 0000:84:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
6. Configure the ports.
a. The E810-CQDA2T supports 2x100 GbE or 8x10 GbE. To switch between the modes you must
use the Ethernet Port configuration Tool (EPCT). It can be found under \APPS\EPCT\Linux_x64
of the complete driver package.
# ./epct64e
Ethernet Port Configuration Tool
EPCT version: v1.38.03.06
Copyright 2019 - 2022 Intel Corporation.
Options:
-? / -h / -help
Displays command line help.
-? (parameter) / -h (parameter) / -help (parameter)
Usage help for specific command line parameter.
-devices [parameter]
Displays supported devices present in the system. If 'branding' parameter
is specified branding view is presented.
-get
Displays port configuration for specified device.
-nic=(device_index)
Selects device with specified index.
-set (option)
Configures device with specified option.
-location (Segment:Bus)
Selects device with specified PCIe Address.
All actions succeeded.
b. To update, you must first find the E810-CQDA2T adapter. In this example, it is NIC 2 (in
2x100 Gbps mode).
# ./epct64e -devices
Ethernet Port Configuration Tool
EPCT version: v1.38.03.06
Copyright 2019 - 2022 Intel Corporation.
NIC Seg:Bus:Fun Ven-Dev Connector Ports Speed Quads Lanes per PF
=== ============= ========= ========= ===== ======== ====== ============
1) 000:024:00-03 8086-1593 SFP 4 25 Gbps Single 1
2) 000:175:00-07 8086-1592 QSFP 2 100 Gbps Dual 4
3) 000:178:00-03 8086-1593 SFP 4 25 Gbps Single 1