Intel E810-CQDA2T - Page 66

Intel
®
Ethernet Network Adapter E810-CQDA2T
User Guide
66 722960-002
# Valid values are defined in Table 11-7 and Table 11-8 of recommendation
# ITU-T G.8264.
# They shall be configured appropriately so they are understood by the peer.
#
# external_input_QL corresponds to the SSM code column.
#
# external_input_ext_QL corresponds to the Enhanced SSM code column
# (is used only if "extended_tlv = 1")
#
external_input_QL 2
external_input_ext_QL 255
#
# If extended TLV shall be supported on the device.
# 0 if no extended tlv shall be supported
# 1 if extended tlv shall be supported
# default: 0
#
# In case of 0:
# - the port will always TX the non-extended TLV, for RX only
# non-extended TLV will be processed for reference signal selection
# In case of 1:
# - If port is configured with external_input=1, the TX will always use
# extended TLV (no RX is required in this case)
# - If port is configured with line or external input mode, the TX version
# of TLV will be propagated from the port that was chosen as
# candidate for frequency synchronization
#
extended_tlv 1
#
# Which network option shall be supported
#
# 1 or 2 as defined in T-REC-G.8264
# default: 1
#
# This is rather per-network option, all device in SyncE network
# shall have this configured for the same value
#
network_option 1
#
# Seconds indicating minimum time to recover from the QL-failed state on the
# port.
# Range: 10-720
# Default: 300
#
# If valid QL was not received from one of the source ports within 5 seconds
# the port is no longer a valid source (marked as QL-failed)
#
# Valid QL must be received for more then "recover_time" seconds on that port
# to use its PHY recovered signal again as a valid source
#