Hardware Installations and Upgrades
Intel® Workstation Board S5520SC Service Guide 39
11. Remove the processor.
12. If installing a replacement processor, see “Installing the Processor”.
13. Reinstall and reconnect any parts you removed or disconnected to reach the processor sockets. Refer to the
documentation that came with your chassis for instructions on installing chassis components.
14. Replace the chassis cover and reconnect the AC power cord. See the documentation that came with your chassis for
instructions on installing the cover.
Replacing the CMOS Battery
The lithium CMOS battery on the workstation board powers the RTC (Real-Time Clock) in the absence of power. When the
battery starts to weaken, it loses voltage, and the system settings stored in CMOS RAM in the RTC (for example, the date
and time) may be wrong. Contact your customer service representative or dealer for a list of approved devices.
WARNING
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s
instructions.
ADVARSEL!
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af
samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
ADVARSEL
Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
VARNING
Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som
rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.
VAROITUS
Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan
suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.
1. Observe the safety and ESD precautions at the beginning of this book. For more information, see “Safety Information”.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord from the server.
4. Remove the chassis cover and locate the CMOS battery. See the documentation that came with your chassis for
instructions on removing the cover.
5. Use a finger to pull the lever away from the top of the battery until it clears the battery. Use caution so you do not bend
the lever.
6. Lift the battery from the socket.
To Next Page
Loading...
Need help?
General
