OW50M - OneWeb Maritime Antenna System
4
Chapter 6. Installing Below Deck Unit (BDU) 45
6.1 Selecting BDU Installation Site 45
6.2 CNX Dimensions 45
6.2.1 CNX Dimensions 45
6.3 Antenna System Configuration 46
6.4 CNX Cable Connection 48
6.4.1 CNX Front Panel View 48
6.4.2 CNX Back Panel View 49
6.4.3 CNX Connector Pinout Guide 49
6.4.4 Connecting CNX to Ship Gyrocompass 51
6.4.5 Connecting to a Wi-Fi network through the Wi-Fi Dongle 52
Chapter 7. Starting Dual Antenna System 53
7.1 Configuration of Dual Antenna System 53
7.2 Configuring Primary & Secondary Role 53
7.2.1 Setting the Compound UT#2 (Secondary) 54
7.2.2 Setting the Compound UT#1 (Primary) 55
7.3 Configuring VLAN, APN, NMEA and CUC IP Address 57
7.3.1 Installation 57
7.3.2 Main Page 58
7.3.3 Configuration 59
7.3.4 Installation 59
7.3.5 Control 60
7.3.6 Monitoring 60
7.4 Completing Installation via Install Wizard 61
7.5 Monitoring Dual Antenna System 66
Chapter 8. Using Local User Interface (LUI) 67
8.1 Introduction 67
8.2 Turning On System 67
8.3 Accessing Webpage 67
8.3.1 TCP/IP Connection through LAN Port 67
8.4 Webpage Layout 68
8.4.1 Navigation bar 68
8.4.2 Home Page 69
8.4.3 Footer 70
8.5 Antenna 71
8.5.1 Antenna Info 71
8.5.2 Massage Stats 72
8.5.3 Modem ↔ Antenna Latency 72
8.5.4 Blockage Zones 73
8.5.5 Antenna Status 73
To Next Page
Loading...
Need help?
General
