Interlogix Advisor Advanced ATS1000A-IP-MM - Fobs; Fob Options

108 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Fobs
4.2 RF fobs
0>Add fob
1 Fob 1
This menu lets you see all programmed fobs, select an existing fob, or create a
new one.
Fob options
4.2.0 Add fob
To add a fob, follow one of the procedures described in “Wireless device
programming” on page 197.
4.2.n Select fob
1>Fob name
Fob 1
Select an existing fob to program.
4.2.n.1 Fob name
1 Fob name
>Fob 1 <
Use the Fob name option to set a fob name. The fob name identifies the fob to
the end-user for alarm reporting or for display of status or error message.
When a fob is created, it is given the default name “Fob Ex.y”, where <x> is the
expander number, and <y> is an expander input number. For example, default
fob name “Fob E2.8” is given to the fob assigned to input 8 on the expander 2.
A fob name can consist of 16 characters.
4.2.n.2 Assigned user
2>Assigned user
User 1
Assign an existing user to the selected fob.
Note: One user can have a few fobs assigned. However, one fob can be
assigned only to one user.
4.2.n.3 Buttons
1>Button 1
2 Button 2
Use the Buttons menu to assign an appropriate function to a button or a button
combination.
Table 29 on page 109 lists buttons and combinations that are available.