Interlogix Advisor Advanced ATS1000A-IP-MM - Advisor Advanced Events

Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 215
Advisor Advanced events
Table 40: Advisor Advanced events
Group
Event
#
Event description
Notes
Zone
ACTIVE
01
Zone active
Zone in active state
TAMPER
02
Zone tamper
Zone in tamper state
AM
03
Zone masking
Zone in anti-mask alarm state
BATTFAULT
04
Zone battery fault
Zone in battery fault state
FAULT
05
Zone fault
Zone in fault state
DIRTY
06
Zone dirty
Zone in dirty state
SVSHORT
07
Zone supervision
short
Zone in short supervision state
SVLONG
08
Zone supervision
long
Zone in short supervision state
INHIBIT
09
Zone inhibited
Zone state changed to inhibited
ISOLATE
10
Zone isolated
Zone state changed to isolated
SOAK
11
Zone in soak test
Soak test is active
SET
12
Zone set
Zone in Part set or Full set mode
ALARM
13
Zone in alarm
Zone in alarm. Restores after
alarm acknowledgement.
RF learned
14
Wireless device
programmed
Active for 3 seconds after a
successful programming
RF signal accept
15
Wireless device
found
Active for 3 seconds after device
response
Inactive days
16
Zone inverted walk
test failed
Zone has been inactive for
longer than inactive day limit
Area
FULLSET
01
Area full set
Area is in full set state
PARTSET1
02
Area part set 1
Area is in part set 1 state
UNSET
03
Area unset
Area is in unset state
ALARM
04
Intrusion alarm
Area Intrusion alarm is active
FSALARM
05
Alarm during full
set
Area alarm while in full set
PSALARM
06
Alarm during part
set
Area alarm while in part set
USALARM
07
Alarm during unset
Area alarm while unset
FTCALARM
08
Alarm and FTC
Area alarm while FTC present
FIREDOOR
09
Fire door active
A fire door local alarm is active
FSFIREDOOR
10
Fire door during full
set
A fire door active while area full
set
PSFIREDOOR
11
Fire door during
part set
A fire door active while area part
set
USFIREDOOR
12
Fire door during
unset
A fire door active while area
unset