Interlogix Advisor Advanced ATS1000A-IP-MM - Page 160

150 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Condition
Description
8.4.2.3 Zone fault
Intrusion detector fault
8.4.2.4 Zone tamper
Tamper in zone
8.4.2.5 Interconnection fault
A critical error caused by communication trouble
between internal panel components
8.4.2.6 Mains fault
Mains fault, including external fault
8.4.2.7 Battery fault
Battery fault, including external fault
8.4.2.8 FTC (Failed to Communicate)
Reporting attempts are failed
8.4.2.9 Siren fault
Siren output fault
8.4.2.10 Zone technical
An alarm in the technical zone
8.4.2.11 Keypad fault
A fault reported by keypad
8.4.2.12 Expander fault
A fault reported by remote expander
8.4.2.13 Comms fault
All transmission paths are down (no communication)
8.4.2.14 Engineer reset
Engineer reset requirement
8.4.2.15 Siren tamper
Siren tamper active
8.4.3 Forced set
3 Forced set
>Off<
The Forced set option enables the forced set feature. The forced set options are
configured below.
Forced set is an option where active zones can automatically be inhibited when
setting an area.
Note: This option should be used with care. Users may not be aware which
zones are inhibited.
8.4.4 Forced set options
4 Forced set opt
>Inh unset<
The Forced set options menu defines when the forced set is possible. The
following options are available.
Table 35: Forced set options
Option
Description
Inhibit till unset
Zone is inhibited until the area is unset.
Inhibit exit
Zone is inhibited until the exit time expires.
Inhibit close
Zone is inhibited until its state changes to normal.