Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 21
Caution: If the PSTN line is provided via the ADSL network, make sure that at
least ADSL splitter/filter is used, otherwise the PSTN communication quality may
be too low for a reliable reporting.
Ethernet connection
Figure 20: Ethernet connection
The Ethernet port is an IEEE 802.3u based connection supporting 10BASE-T or
100BASE-TX link speeds.
Use only FTP Cat 5e type cable for Ethernet connections.
In ATSx000A(-IP), place FTP Ethernet cable through the ferrite, wrap the cable
around and bring it through again as it is shown in “Advisor Advanced housings”
on page 1. Close ferrite securely.
To Next Page
Loading...
Need help?
General
