Interlogix TruVision - Page 17

Installation Guide 13

Address settings
Use the SW1 switches from 1 to 4 to set the PTZ dome
address. Refer to Table 1 on setting the PTZ dome address to
a specific number.
Table 1: Set the dome address between 0 and 15
Dome
address
Switch no.
1 2 3 4
0 OFF OFF OFF OFF
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
4 OFF OFF ON OFF
5 ON OFF ON OFF
6 OFF ON ON OFF
7 ON ON ON OFF
8 OFF OFF OFF ON
9 ON OFF OFF ON
10 OFF ON OFF ON
11 ON ON OFF ON
12 OFF OFF ON ON
13 ON OFF ON ON
14 OFF ON ON ON