Installation Guide 29
Dome
address
Switch no.
1 2 3 4 5 6 7 8
251 ON ON OFF ON ON ON ON ON
252 OFF OFF ON ON ON ON ON ON
253 ON OFF ON ON ON ON ON ON
254 OFF ON ON ON ON ON ON ON
255 ON ON ON ON ON ON ON ON
Baud rate settings
Use the SW2 switch numbers 1 and 2 to set the baud rate of
the PTZ dome. The baud rate can be 2400 bps, 4800 bps,
9600 bps or 19200 bps. The baud rate will be set as 2400 bps
by default if it is out of this range. Refer to Table 6 below:
Table 6: Set the baud rate of the dome
Baud rate
SW2 switch no.
1 2
2400 OFF OFF
4800 ON OFF
9600 OFF ON
19200 ON ON
To Next Page
Loading...
