48 Installation Guide
Screw holes
Cable hole
H. Install the HD-TVI PTZ dome on to the mounting
base.
Route the cables for the HD-TVI dome. Align the
base of the HD-TVI dome with the mounting base.
Align the direction of the arrow with the spring end of
the mounting base.
Push the HD-TVI dome upwards (1) and then
forwards (2) in the direction of the arrow. When the
HD-TVI dome is in position, the spring will
automatically snap into the lock clip firmly. See the
figure below:
To Next Page
Loading...
Need help?
General
