EN
A
Programming command
ON
Programm
OK
Neu
OK
Mit Datum?
Ja / Nein
OK
Menu
Program
New
With Date?
Yes/No
OK
Zeit
09:01
Stunde
OK
Zeit
09:50
Minuten
OK
Tage
12345--
Mo-Fr
Select FNC
ON
Time
09:01
Hour
Time
09:50
Minutes
Days
12345--
Mo-Fr
Kanäle
(1)
1
CH1
OK
Weitere Schaltzeit?
Ja/Nein
OK
Priorität
(2)
Hoch
OK
Channels
(1)
1
Add Time?
Yes/No
CH1
Priority
(2)
High
1. Press the
Menu
button:
2. Select
Program
and conrm with
OK.
For clarication of the following action steps, see ow chart.
3. Select
New
and conrm with
OK
.
4. In step
With Date
?
,specify whether the device is to be activated on a certain date and - if yes -
conrm with
OK
(also refer to Seite 52).
5. Select
ON
and conrm with
OK
.
6. Enter hour and minute of the switch-on time (+/-) and conrm each with
OK
.
NOTE: The data for sunrise and sunset should be considered in connection with the astro-variant.
The choice of these parameters is between 11 p.m. and midnight.
7. Set the weekday(s) (+/-) to which the switching time should apply, and conrm with
OK
.
NOTE: The weekdays 1-5, 6-7 and 1-7 are preset. Individual weekdays can be set (+/-) under
"Select days".
8. Select channel
(1)
(+/-) for which the switching time should be set, and conrm with
OK
.
NOTE: The plus sign stands for an active, the minus sign for an inactive channel.
9. Select
YES
to create an additional switching time, or select
NO
to determine the possible
priority
(2)
.
(1)
The channel selection is only available with 2-channel timers
(2)
The choice of priority is only possible in advanced mode; refer to „Dening prioritisation of programs“
auf Seite 61.
54
To Next Page
Loading...
Need help?
General
